"Could not load file or assembly 'IPRO.EDD.DiscoveryCPP'" error using Electronic File Report in iConvert+
Applies to: iConvert+
Version: Pre-1.0.9.0


Symptom
When attempting to use the Electronic File Report feature in iConvert+, an error message is returned: Unhandled exception . . . Could not load file or assembly 'IPRO.EDD.DiscoveryCPP' . . . or one of its dependencies. An attempt was made to load a program with an incorrect format.


Possible resolution 1
This error will occur when attempting to run versions of iConvert+ earlier than 1.0.9.0 on a 64-bit operating system. To resolve the issue, upgrade iConvert+ to a version of 1.0.9.0 or later; Ipro software downloads are available from the MyIpro website.